Schneider SL 300C-CB A++ NF Bedienungsanleitung Seite 39

 The door seal is damaged or soiled.
The door makes a strange sound when opened.
 The door seals are soiled.
 The appliance is not installed on a
level, dry and solid floor.
 The appliance is in contact with a
wall or another item. The bottles are
incorrectly positioned.
 Some items have dropped behind
the appliance.
 The water pan (located at the rear
bottom of the cabinet) may not be
properly levelled, or the draining
spout (located underneath the top of
the compressor depot) may not be
properly positioned to direct water
into this pan, or the water spout is
blocked.
 The LED light may be damaged.
 The control system has disabled the
lights due to the door being kept
open too long.
 If the appliance shows a malfunction not noted on the schedule above or if you
have checked all items on the above schedule but the problem still exists, please
contact the aftersales service.
The operating procedures described below are normal
 The refrigerant generates a sound similar to flowing water.
 Sometimes you may hear a sound which is generated by the injection process of
the cooling circuit.
 The sides of the appliance may get warm while the appliance is running.
When you run the appliance for the first time or the temperature falls below a
certain level the appliance will operate with high power to reach the preset
temperature.
May be generated inside or outside the appliance by high humidity or very warm
Unusual noise.
Water drips on the floor.
The light is not working.
and do not indicate a malfunction.
Distinct noise
Condensed water in/on the appliance
 Clean/replace the door seal.
 Clean the seals.
 Realign the appliance.
 Readjust the appliance.
 Realign the bottles
 Remove these items.
 You may need to pull the refrigerator
away from the wall to check the pan
and spout.
 Refer to replace LED lights in
cleaning and care chapter.
 Close and reopen the door to
reactivate the lights.
39