Philips QC5099 Bedienungsanleitung Seite 10

English
10
Cleaning
Clean the appliance every time you have used it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as alcohol, petrol or acetone to clean the appliance.
Only clean the appliance and the adapter with the cleaning brush
supplied.
1 Make sure the appliance is switched off and disconnected from the
mains.
2 Pull the comb attachment off the appliance (Fig. 5).
3 Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (Fig. 6).
Be careful that the cutting unit does not fall to the floor.
4 Clean the cutting unit with the cleaning brush supplied (Fig. 8).
5 Clean the inside of the appliance with the cleaning brush supplied.
6 Place the lug of the cutting unit into the slot and push the unit back
onto the appliance ('click') (Fig. 7).
Note: This appliance does not need any lubrication.
replacement
Only replace a damaged or worn cutting unit with an original Philips
cutting unit.
1 Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (Fig. 6).
2 Place the lug of the new cutting unit into the slot and push the unit
back onto the appliance ('click') (Fig. 7).