Technical Specifications; Power Supply - Philips SBC SC477 DECT Bedienungsanleitung

Talk-back not
working *
Intercom function
not working *
DECT system check
light (flashing red)/
System check alarm
beeps on Parent Unit
Speaker volume of Baby Unit is set to 0. Set speaker volume to 1 or higher.
Baby Unit is in the baby monitor mode. Set Baby Unit in the intercom mode.
Speaker volume of Baby Unit is set to 0. Set speaker volume to 1 or higher.
Units too far away from each other.
Units too far away from each other.
Batteries are low.
Units cannot establish a connection,
even when close to each other.
*) In talk/intercom function, when either the Parent or Baby Unit is
transmitting, the other unit can only receive and not transmit.
The TALK function of the Parent Unit has priority over that of the Baby
Unit. When both switches are pressed simultaneously, the Parent Unit
TALK function will be activated.

Technical specifications

Power supply:

Operating range:
Operating temperature: 0 °C to 40 °C
Standard:
Only use the AC power adapter included or a type that complies with
safety standard EN60950 and has the following specification:
9 Volt DC/ 200 mA.
Decrease distance between units.
Decrease distance between units.
Replace/recharge batteries.
Try solving the problem by using the factory
initialisation mode.
– Battery pack; rechargeable NiMH for Parent
Unit (included)
– Optional batteries 4 x 1.5V; AA for
Baby Unit (not included)
– AC power adapter 230V AC, 50 Hz
Up to 300 metres in ideal conditions.
Range will be affected by walls, doors, etc.
Indoors the range may decrease to 50
meters
Digital Enhanced Cordless
Telecommunications (DECT)
ENGLISH
13