Adjusting Microphone Sensitivity; Using The Family Intercom System - Philips SBC SC477 DECT Bedienungsanleitung

Adjusting microphone sensitivity

1 Set the Single Point Control mode switch (19) on the Parent Unit to
BABY SENSITIVITY.
2 Press the Single Point Control +/- button (20) on the Parent Unit to
increase/decrease the microphone sensitivity of the Baby Unit.
> The sound-level lights (12) on the Parent Unit give visual feedback about
the setting for approximately 3 seconds.
0 lights = minimum level
5 lights = maximum level (continuous transmission)
Note: When set to maximum level (continuous transmission), the Baby Unit
Note:You can only change the Baby Unit sensitivity if the connection between

Using the family intercom system

Talking back to comfort your baby
1 Set up both units to MONITOR your baby's sounds.
2 Adjust the loudspeaker volume level of the Baby Unit, using the Single Point
Control switch and buttons, to a level you prefer.
3 On the Parent Unit, press and hold the TALK button (15) and talk clearly
LEVEL
SYSTEM
into the microphone.
While the TALK button on the Parent Unit is being pressed, no sounds from
POWER
the Baby Unit can be heard on the loudspeaker of the Parent Unit.
Note: Wait with talking until the system check light is blinking green.
Note: In case the loudspeaker volume of the Baby Unit is set to 0 the system
4 Release the TALK button when finished.
monitors continuously and all sounds, regardless of level, can be heard on
the Parent Unit. Battery operating time may decrease to approximately
8 hours during continuous transmission.
the Baby Unit and Parent Unit is established
check light will light red, while pressing the TALK button.
ENGLISH
9