Problem Solving; Technical Specifications - Philips SBC SC362 Bedienungsanleitung

Power light does not light
High pitched noise.
No sound.
Power light blinking.
Interference or poor
reception.
Power supply
– Optional batteries 4 x 1.5V; AA alkaline for Parent Unit (not included);
– Optional batteries 4 x 1.5V; AA alkaline for Baby Unit (not included);
– AC power adapter 230V AC, 50 Hz (two included): - Output voltage 9V DC, 200mA.
Only use the AC power adapter included or a type that complies with safety standard EN60950 and that
has the following specification: 9 Volt DC / 200mA.
Operating range
– up to 150 metres in ideal conditions (walls and floors can limit this distance).
– 10°C to 40°C
Pilot tone
– Continuous communication link (hidden signal ensures a continuous link between both units so you
only hear your baby's sounds).
Transmission frequencies
SBC SC362/86U & SBC SC362/87U:
SBC SC362/05U (IRE, UK):
SBC SC362/13U (SE):
SBC SC362/16U (ES):
Downloaded from www.Manualslib.com
Problem
Unit is not turned on.
AC adapter is not plugged in or
Batteries are exhausted.
AC adapter plugged into an
outlet that is not working.
Units are too close together.
Volume too high.
Volume control on Parent unit is
set too low.
Units are out of range.
Batteries are low or empty.
Mobile or cordless phones too
close to the baby monitor can
cause interference.
T
ECHNICAL SPECIFICATIONS
manuals search engine
P
ROBLEM SOLVING
Possible Cause
Channel A Channel B
40.695 MHz 40.675 MHz
49.890 MHz 49.830 MHz
27.145 MHz 27.095 MHz
31.350 MHz 31.000 MHz
5
Solution
Parent unit:- turn Volume control/
Off switch clockwise (B–3).
Baby unit:- set mode switch (A-6)
to the VOICE position.
Plug in AC adapter or replace
batteries.
If the power socket has a switch,
turn it on.
Move Parent unit away from
Baby unit.
Turn volume control on Parent
unit counter-clockwise.
Turn volume control/Off switch
clockwise (B–3).
Move Parent unit closer to Baby
unit.
Replace batteries or connect to
mains power.
Move the phones away from the
units.