Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Intended Use
This set in intended for making punching holes in (e.g.) sealing
compounds, cardboard etc.
The set contains thirteen exchangeable hole punches with the
following diameters:
5 – 6 – 8 – 10 – 11 – 13 – 16 – 19 – 22 – 25 – 28 - 32 and 35 mm,
a quick change punch holder with ergonomic handle design and a
spring-loaded centering mandrel.
Hints: Best results will be achieved when using it on an even and
flat surface. Preferably use it on a wooden surface because metal or
other very hard surfaces may damage the hole punches.
Using
1. Mark the center of the hole to be
punched out.
2. Choose
punch and screw it on the punch
holder.
3. Apply the spring loaded-centering
pin at the marked center.
4. Hold the punch holder vertically to
the work piece.
5. Hit the top of the punch holder with
a hammer. Note: Hitting too hard
may damage your hole punch
while hitting too soft may not cre-
ate a proper hole in your work
piece.
the
appropriate
Operation
hole
IV
Werbung
