Activating The Dip Switch Functions - STG-BEIKIRCH WRZ 40M-4G Bedienungsanleitung

DIP-switch 9: Control of solenoid valves in pneumatic systems
Motor groups are supplied with power in pulses for a period of 2 sec. after a change of status in direction OPEN or
CLOSED
1 2 3 4 5 6 7 8 9 10 11 12
DIP-switches 5, 10, 11, 12: Setting the status and wind speed indicator (2 x 7 segment display)
ON OFF
5 Display the wind speed. This is used to adapt
the display when the control board is fitted at
180° for the purpose of changing the cable
routing from bottom to top
5
Normal mode, wind speed displayed
(e.g.: 13 m/s)
10
Display the current wind speed. If zero, 0m/s is displayed.
When the selector switch is operated, the current position
(MANUAL/AUTOMATIC/CLOSED) is displayed for approx.
15 sec., then the current wind speed is displayed again
10 The current wind speed is displayed if greater than zero.
Otherwise the current position (CLOSED/AUTOMATIC/
MANUAL) is displayed
wind speed
11 + 12
Display the wind speed of
11 12
Display the wind speed of
11 + 12
Alternating display the wind speed of
and 2
12 11
Display "E" = "Error",
a combination error in the DIP switches
Setting
7.1

Activating the DIP switch functions

Attention! First disconnect the control panel from the mains, then carry out the setting or change on the DIP
switch.
After the settings to the DIP switch are finished, the 230 V AC mains supply is switched on or connected. The changed
functions are adopted in the memory.
01/13424999503
Function
AUTOMATIC HAND
CLOSED
wind-/rain detector
1
wind-/rain detector
2
wind-/rain detector
Wind-/Rain-control unit WRZ 40M-4G
Setting DIP-switch
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10 11 12
1
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10 11 12
37