Information On The Solar Module - SOLARWATT 36M glass Montageanleitung

cOngRAtulAtiOns On the
PuRchAse Of YOuR sOlARWAtt sOlAR MODule
These instructions describe the assembly, connection,
maintenance, and disposal of solar modules. Please read them
carefully and comply with them accordingly.
The installation and electrical connection of photovoltaic
systems may only be carried out by specialist personnel,
who are familiar with this work through their professional
qualifications. For the installation of the other components,
comply with the relevant installation instructions from the
manufacturer. The manufacturer is unable to monitor whether
these instructions and the conditions and methods for instal-
lation, operation, use, and maintenance of the inverter are
complied with.
Incorrect installation can cause damage to property, which
could consequently pose a risk to people. SOLARWATT accepts
no responsibility or liability for losses, damage, or costs resul-
ting from incorrect installation, operation, use, or mainte-
nance or losses, damage, or costs which are connected to any of
the above in any way. The SOLARWATT installation instructions
should be made available to the operator as part of the solar
power system documentation and stored by the operator.
Comply with the guidelines, laws, and regulations valid in the
relevant country when planning, setting up, and operating
grid-connected PV systems. For information on additional
requirements, please contact the responsible local authorities
and the network operator.
SOLARWATT solar modules are made from high-quality materials
and high-performance solar cells, and are therefore extremely
reliable. The quality of the solar modules made exclusively in
Germany is ensured by multiple tests carried out on the pro-
8 STaTuS: 06/2016 | aT-TM-PMS-0917 | inSTallaTion inSTrucTionS | rev. 000 | Subject to change | © 2016 SolarWaTT GmbH
ducts throughout the entire production process. SOLARWATT
solar modules are VDE-tested and fulfill the requirements
of the extended test standard IEC 61215 Ed.2, as well as the
safety standard IEC 61730. In SOLARWATT's own research and
development department, tests are carried out using measu-
ring, testing, and environmental simulation equipment which
go above and beyond the current valid standards and enable
us to optimize our products continually. If treated correctly,
your SOLARWATT solar modules will offer you several decades
of service.
SOLARWATT recommends insuring the PV system against
reduced yields or damage with SOLARWATT Full Coverage for
complete security. Further information is available from your
SOLARWATT partner or online at www.solarwatt.de.

Information on the solar module

Detailed electrical and mechanical properties for your specific
module type can be found on the relevant data sheet. The key
technical data under standard test conditions [STC, solar cell
temperature: 25°C, irradiation: 1,000 Watt/m², air mass: 1.5
(corresponds to a sun elevation angle of 41.8°)] can also be
found on the nameplate of the solar module.
WARning
Failure to comply with the installation instructions results
in the warranty and guarantee becoming null and void.