Fenix MR 300 Bedienungsanleitung Seite 9

Panel Removal
Before releasing the mounting brackets, disconnect the panel from the mains by doublepole switch. Using tools,
release erection bolts and lift the panel vertically upwards to release the brackets from the screws. It is also
necessary to disconnect the power supply cable from the wall junction box.
Notice
Only a qualified person is allowed to work on the panel. The panel must be disconnected from the power supply
before starting any work. Because the natural marble is a material, it is necessary to be careful during transport,
manipulation and montage. The marble slab may only be cleaned with detergents which will not impair the surfa-
ce quality (polish).
Before switching on the panel for the first time its temperature must be the same as the temperature in the room where it is to
be installed (and at a minimum of +3°C above zero).
Important Safety Instructions
Do not cover your heating unit in any way.
The "DO NOT COVER" warning tag is there to
remind you that any material covering the unit
can catch fire. Never place or hang any furniture
or curtains in front of the panel (see Fig. 7) and
ensure free air circulation.
Regularly, at least each time before starting a
heating season, clean the panel from dust.
Do not touch the panel from the bath/showerbath.
The panel may be mounted to the grounds of
flammability classes C and D.
This appliance is not designed to be used by people (including children) whose physical, sensorial or mental
disability or lack of experience and knowledge prevent them from safely operating the appliance, unless they are
supervised or were instructed how to use the appliance by a person who is responsible for their safety.
Children should be supervised in order to ensure that they won't play with the appliance.
For first marble panel start- up is necessary to keep a starting temperature time as
is mentioned in table below in order to prevent marble stone desk cracking by
reason of very fast temperature increasing:
9
fig. 7
ATTENTION!
20 minutes Switch- ON
30 minutes Switch- OFF
30 minutes Switch- ON
30 minutes Switch- OFF