General Operation; Playing Cds/Mp3; Listening To The Radio - AEG MC 4462 BT Bedienungsanleitung

English
42

General operation

NOTE:
• Some buttons may be found both on the unit and the
remote control. Identical buttons have the same func-
tion.
• The operation of the unit is described by the buttons
on the unit.
Infrared remote control
For wireless operation from a distance of up to 5 meters.
If this distance decreases, the batteries must be replaced.
During operation, ensure a clear view between the remote
control and the sensor (3) on the unit.
Turning device on/ off
• Press the STANDBY button (11) to turn the device on.
• To turn off the device, press the
again. The control lamp STANDBY (4) lights up red.
NOTE:
After about 15 minute without a signal, the device will
automatically switch to standby.
Volume
You can adjust the desired volume with the VOLUME control
(12).
FUNCTION (18)
Press the FUNCTION button until the desired operating
mode is shown on the display.
DISCO-LIGHT (19)
Use this button to select between the different lighting
modes for the speakers.
Press the DISCO-LIGHT button repeatedly to select between
the different lighting modes. The "OFF" setting will deacti-
vate this function.
EQ (16)
Press the EQ button repeatedly to select between the preset
equalizer sound modes. The following are available for selec-
tion: (FLAT, CLASSIC, ROCK, POP, JAZZ).
Headphone jack ( )
For headphone operation, use headphones with a 3.5 mm
jack plug that you plug into the head phone connection on
the back of the unit. The speakers are switched off.

Listening to the Radio

1. Select the radio mode with the FUNCTION button (18).
2. You have two options to search for and preset radio sta-
tions.
STANDBY button
During stereo reception, the symbol "
in the display.
Selecting preset radio stations
The preset radio stations may be selected by repeatedly
pressing the FOLD.+/+10 / FOLD-/-10 buttons.

Playing CDs/MP3

1. Select the CD mode with the FUNCTION button (18).
2. Open the CD tray (7), by pressing the PUSH TO OPEN
3. Insert an audio CD with the printed side facing upwards
4. The total number of tracks and playing time will be shown
5. The CD will play from the first title. For audio CDs: The
6. In order to remove a CD, please press the button (8),
Always keep the CD deck closed.
• Automatic station scan:
Important! Any previously preset radio stations will
be overwritten.
Press the button (1). The system will search the
entire FM frequency band for radio stations. The
stations found will be stored in ascending order of
frequency.
• Manually searching for radio stations:
Briefly press the TUN.-/TUN.+ buttons (13), until you
have found the radio station that you are looking for.
If you keep one of the buttons pressed down, the sys-
tem will search to the next or previous radio station.
Storing stations:
1. Search for the desired radio station with the
TUN.-/TUN.+ buttons (13).
2. To store the radio station, press the PROG./
P-MODE button (20). The message "P 01" will
flash on the display and "PROG" will be shown.
3. Select the desired preset location using the
FOLD.+/+10 / FOLD-/-10 buttons (10).
4. Press the PROG./P-MODE button. The radio
station will be preset.
NOTE:
The following will appear in the display "CD".
button (9).
on to the central cone so that the CD clicks into place
and then close the lid of the CD compartment.
on the display after a few seconds.
NOTE:
For CDs in the MP3 format, the number of folders and
the total number of tracks will be shown.
elapsed playing time and the current track will be shown
in the display. For CDs in the MP3 format: The elapsed
playing time and alternately the current track and the
current folder will be shown on the display.
open the CD compartment and lift the CD out carefully.
" will be shown