Troubleshooting - Noxon Fun Anleitung

6. Troubleshooting

Error
The device does not switch on.
No sound.
No network connection can be established. 1. Check the WLAN function.
WLAN connection cannot be established.
No station is found.
Hiss in FM mode.
Alarm does not work.
System freezes suddenly.
Remedy
Check it the power adaptor is connected
properly.
1. Turn on the sound as it may be muted
2. Increase the volume.
2. Try to set an IP address at the device.
3. Activate the DHCP function on the rou
ter and make the connection again at the
device.
4. A firewall is activated on the network –
set the respective program in such a way
that access is possible.
5. Reboot the unit to try.
1. Check the availability of WLAN network
on the access point.
2. Place the device closer to the router.
3. Make sure the WEP/WPA password is
correct.
1. Check the network as well as the ac
cess point and firewall.
2. The station may not be available cur
rently, try it again later or Select another
station.
3. The link of the station is changed or the
station no longer transmits – ask the provi
der for information.
4. The link of manual added station is not
correct, make sure it is correct and re-eter.
1. Check/move the FM antenna.
2. Move the radio.
1. Switch on the alarm.
2. Due to the volume setting, refer to the
solutions of "No sound".
3. The source of alarm was set to be stati
on but there is no network connection.
Change the source of alarm or reconfigu
re the connection.
The radio is overloaded, reboot the unit.
55