Troubleshooting - Noxon iRadio Bedienungsanleitung

NOXON iRadio
6.

Troubleshooting

Error
The device does not switch on .
No sound .
No network connection can be established . 1 . Check the WLAN function .
WLAN connection cannot be established .
No station is found .
Alarm does not work .
System freezes suddenly .
48
Remedy
Check it the power adaptor is connected
properly .
1 . Turn on the sound as it may be muted
2 . Increase the volume .
2 . Try to set an IP address at the device .
3 . Activate the DHCP function on the rou
ter and make the connection again at the
device .
4. A firewall is activated on the network –
set the respective program in such a way
that access is possible .
5 . Reboot the unit to try .
1 . Check the availability of WLAN network
on the access point .
2 . Place the device closer to the router .
3 . Make sure the WEP/WPA password is
correct .
1 . Check the network as well as the ac
cess point and firewall.
2 . The station may not be available cur
rently, try it again later or Select another
station .
3 . The link of the station is changed or the
station no longer transmits – ask the provi
der for information .
4 . The link of manual added station is not
correct, make sure it is correct and re-eter .
1 . Switch on the alarm .
2 . Due to the volume setting, refer to the
solutions of "No sound" .
3 . The source of alarm was set to be stati
on but there is no network connection .
Change the source of alarm or reconfigu
re the connection .
The radio is overloaded, reboot the unit .