Technical Data; Battery Charging - Bosch GAS Professional 18 V-LI Originalbetriebsanleitung

OBJ_BUCH-2315-001.book Page 12 Friday, April 10, 2015 3:49 PM
12 | English

Technical Data

Cordless dry vacuum cleaner
Article number
Container volume (gross)
Vacuum, max.
Airflow, max.
Weight according to EPTA-Procedure 01/2003
Permitted ambient temperature
– during charging
2)
– during operation and during storage
Recommended batteries
Recommended chargers
Operating duration per battery-pack charge
– Vacuuming power "High"
– Vacuuming power "Low"
Technical data determined with battery from delivery scope.
1)
depending on the battery pack being used
2)
Limited performance at temperatures <0 °C
3)
only for wireless charging batteries
Assembly

Battery Charging

 Use only the battery chargers listed on the accessories
page. Only these battery chargers are matched to the lith-
ium-ion battery pack used in your vacuum cleaner.
Note: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The battery must be removed from the vacuum cleaner to
charge it.
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
The lithium-ion battery is protected against deep discharging
by the "Electronic Cell Protection (ECP)". When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
 After the automatic shut-off of the vacuum cleaner, do
not continue to press the On/Off button. The battery
pack could become damaged.
The battery is equipped with a NTC temperature control
which allows charging only within a temperature range of be-
tween 0 °C and 45 °C. A long battery service life is achieved
in this manner.
Observe the notes for disposal.
1 609 92A 108 | (10.4.15)
GAS 14,4 V-LI
3 601 JC6 0..
l
kPa
l/s
kg 1.5/1.3
°C 0...+45
°C –20...+50
GBA 14.4V..
AL 18..
GAL 3680
min/Ah
min/Ah
Removing the battery (see figures A1 – A2)
The battery 6 is equipped with two locking levels that should
prevent the battery from falling out when pushing the battery
unlocking button 13 unintentionally. As long as the battery is
inserted in the power tool, it is held in position by means of a
spring.
– To remove the battery pack 6, press the battery unlocking
button 13 and pull the battery pack toward the rear out of
the vacuum cleaner. Do not exert any force when doing
this.
Mounting VAC Accessories (see figure B)
 Remove the battery before cleaning or performing
maintenance on the vacuum cleaner, making tool ad-
justments, changing accessories or storing the vacuum
cleaner. This safety measure prevents the vacuum cleaner
from being started accidentally.
The vacuum cleaner accessories can be connected directly to
the dust cup 8.
The combination possibilities of the various vacuum cleaner
accessories can be viewed in the figure.
– Connect the vacuum cleaner accessories firmly to the con-
nection at the dust cup 8 and in to each other.
GAS 18 V-LI
3 601 JC6 1..
0.7 0.7
3.7 4
18.7 19.3
1) 1)
1.6/1.4
0...+45
–20...+50
GBA 18V..
GBA 18V... W
AL 18..
GAL 3680
3)
GAL 18... W
8 9
20 20
Bosch Power Tools