Troubleshooting - Carbest ASR 680 Gebrauchs- Und Installationshandbuch

I N N O VAT I O N S
FOR MOBILE LIFE

6.4 Troubleshooting

PROBLEMS
The satellite dish cannot be
opened
Error: satellite not found
Error: rotation maximum
stress
Error: elevation maximum
stress
Rotation error
Elevation error
Error: insufficient
power supply
Error: unstable
power supply
The satellite dish
loses the signal
RF cable error
CAUSES
-No power supply to the satellite
dish
-An obstacle is on the satellite dish
-The vehicle is moving or engine
is on
-Loose or broken connection
- Obstacles in front of the satellite
dish (trees, metal walls, buildings,
etc.) prevent the reception of the
signal.
- The connection from the box to
the LNB is loose
- You are outside or at the extreme
limits of the satellite footprint
- there are obstacles in the area of
action of the satellite dish (trees,
ice or snow)
- there are obstacles in the area of
action of the satellite dish (trees,
ice or snow)
- the rotation motor does not work
- the elevation motor does not
work
- the battery is too low and cannot
ensure the correct operation of
the system
- faulty battery or presence of non
stabilised power supply
- slow connections
- strong storm or wind
broken or disconnected satellite
cable
22
SOLUTIONS
-Check the power supply & fuse
-Switch the control panel on
- Remove the obstacle
- Stop the vehicle and turn off
- Check the connections
- Move the vehicle away from
anything that prevents satel-
lite reception and make sure
that the South is free from ob-
stacles
- tighten the connectors and try
again
- Make sure that you have fol-
lowed the instructions in para-
graph 4.7; otherwise wait until
you arrive in a more central
area
- remove the obstacles that pre-
vent rotation
- Remove the obstacles which
are causing the obstruction .
- check the connections of the
grey cable to the box from the
satellite dish to the external
unit position
- check the connections of the
grey cable to the box from the
satellite dish to the external
unit position
- charge the battery
Turn off any current generators
or have the battery checked
- check and tighten the F con-
nections of the box, satellite
dish and decoder
- wait until the storm or wind
cease
- check the connection
- check the supply voltage
- check the LNB