Accessories - WOLFF Linocut 040262 Originalbetriebsanleitung

place the Linocut into the seam (pic. 3)
press down the blade showing towards yourself,
then push the Linocut forward. Always press the
Linocut towards the lower sheet, that serves as
guide.
before reaching the wall, press down the opposite
blade and pull the Linocut towards yourself.
The Linocut cuts from wall to wall.
Because of the tilting mechanism, the Linocut does not
need to be removed from the seam.
With the two blades the seam can be completely cut from
wall to wall without using a straight edge.
The Linocut is inserted into the overlap (step 1) and led
along the lower sheet (step 2).
Then the handle is tilted (step 3) and the remaining part is
cut with the second blade (step 4).
2.1 Hand posture
On account of the ergonomic form a light pressure is
exerted with the push movement automatically against the
leading edge of the floor covering.
The edge pressure is likewise generated by this ergonomic
clutch posture, without you must pay attention to it.
2.2 Blade protection
Absolutely attach blade protection after the work. Very sharp
blade! You may cause injury without using the blade
protection!

3.0 Accessories:

Replacement blades, 10 pcs. p.u. . . . . . . . . . . . . .#013429
Blade protection . . . . . . . . . . . . . . . . . . . . . . . . . . .#047236
Guide plate for needlepunch felt, 4 mm# . . . . . . . .#013431
Guide plate for carpe, 8 mmt . . . . . . . . . . . . . . . . .#013432
Edge cutting stop ....................................................#063636
Guide plate for wall cove base . . . . . . . . . . . . . . . .#013433
For using the Linocut for reverse
scribing or cutting along the wall.
Linocut #040262 10/2012
pic. 5
step
Schritt 1
step
Schritt 2
pic. 6
step
Schritt 3
step
Schritt 4
5