WOLFF Linocut 040262 Originalbetriebsanleitung Seite 4

Operating manual
Linocut
Read before use and keep safe
Comes with:
Linocut + 10 blades
Blade protection
(2) (1)
Linocut #040262 10/2012
exact cut without straight edge from wall to wall
cuts top sheet whilst using lower sheet as guide
seam width adjustable
can be used with Linoleum laid in the adhesive
1.0 Adjusting the Linocut
1.1 Adjusting the seam width
The Linocut comes with 2 mounted blades and can be used
pic. 1
immediately. The blades are adjusted to cut a close seam.
To cut a wider seam:
pic. 2
turn screw (1) counterclockwise (use a screwdriver
or coin)
(3)
check the seam width before starting work
1.2 Adjusting the depth of the cut
The Linocut has 2 knurled knobs (3) for adjustment of the
depth.
By turning the knurled knobs, the desired cut depth can
be adjusted. (Figure 2)
pic. 3
1.3 Changing the blades
remove screws (2) and the blades
insert new blades and tighten screws (2) again
2.0 Use
pic. 4
After laying the sheets onto the adhesive bed, they should
overlap approx. 1 cm.
The edge of the sheet that is installed first has to be pre-cut
(e.g. with the Wolff stripe cutter) and serves as guide for the
overlapped sheet.
English
#040262
4