Reset Function - Philips AVENT SCD525 Benutzerhandbuch

7.10 Reset function

This function in the menu of the parent unit
allows you to reset both the parent unit and the
baby unit to the default settings at the same time.
You can use this function if problems occur that
you cannot solve by following the suggestions
in chapter 'Frequently asked questions'.
Select 'Settings' with the + and - buttons.
1
Press the OK button to confirm.
2
Select 'Reset' with the + and - buttons.
3
Press the OK button to confirm.
4
• The message 'Confirm?' appears on the
display of the parent unit.
Press the OK button to confirm.
5
The parent unit switches off and then
•
switches on again.
• The units have now both been reset to the
default factory settings.
7.10.1 Default settings
Parent unit
•
Language: English
•
Loudspeaker volume: 1
• Microphone sensitivity: 5
• Sound alert: off
•
Temperature alert: off
•
'Temperature low' alert: 14°C
•
'Temperature high' alert: 35°C
• Temperature scale: Celsius
•
ECO mode: off
Baby unit
•
Loudspeaker volume: 3
•
Nightlight: off
• Lullaby: off
14
8 Accessories
8.1 Belt clip and neck strap
If the batteries of the parent unit are sufficiently
charged, you can take the unit with you inside
and outside the house if you attach the unit to
your belt or waistband with the belt clip or if you
hang it around your neck with the neck strap. This
allows you to monitor your baby while you are
moving around.
8.1.1 Connecting the belt clip
Snap the belt clip onto the parent
1
unit (Fig. 32).
8.1.2 Disconnecting the belt clip
Pull the belt clip off the parent unit.
1
8.1.3 Connecting the neck strap
Insert the end loop of the neck strap through
1
the hole behind the strap post. Thread the
neck strap through the end loop and pull the
neck strap tight (Fig. 33).
8.1.4 Disconnecting the neck strap
Pass the neck strap though the end loop and
1
pull the end loop out of the hole behind the
strap post.