Maintenance And Service; Maintenance And Cleaning - Bosch PFS 105 E Originalbetriebsanleitung

OBJ_BUCH-420-003.book Page 17 Monday, October 14, 2013 2:59 PM
– Avoid interruptions within the spray surface.
Guiding the spray gun evenly will provide uniform surface
quality.
Non-uniform clearance and spray angle lead to heavy forma-
tion of paint mist and thus to an uneven surface.
– End the spraying procedure outside the target area.
Never completely empty the container for the spray material
by spraying. If the suction tube is no longer immersed in the
spray material, the spray jet will be interrupted and this will
result in an inconsistent surface.
When coating material builds up on the nozzle and air cap,
clean both parts with the corresponding solvent.
Adjusting the Spray Pattern (see figure F)
 Never actuate the trigger switch 9 while adjusting the
air cap 2.
– Loosen the union nut 3.
– Turn the air cap 2 to the requested position.
– Firmly retighten the union nut.
Air cap Spray jet Application
pattern
A
Vertical flat jet for horizontal
working direction
B
Horizontal flat jet for vertical
working direction
C
Round jet for corners, edges and
hard to reach locations
Adjusting the Spraying Capacity (see figure G)
– To adjust the requested spraying capacity, turn the thumb-
wheel 5:
I: Min. spraying capacity,
IIII: Max. spraying capacity.
Spraying capacity
Too much material on target area: The spraying capacity
Not enough material on target
area:
Bosch Power Tools
Adjusting the Air Flow (see figure H)
– Turn control knob 16 to adjust the air flow and the pres-
sure for the spray material being used.
Minimal air flow
It is recommended to start with the maximum air flow.
Air Flow
Too much fog of coating
material:
Atomisation too coarse:
Transport
The filled spray gun or a closed container with spray material
can be placed in the set-down port 17 for transport. The hold-
ing fixture retains the spray gun firmly in the set-down port.
Spray material cannot run out.
– Place down the spray gun on the set-down port and push in
against the resistance until tightly seated.

Maintenance and Service

Maintenance and Cleaning

 Before any work on the machine itself, pull the mains
plug.
Cleaning (see figures I–K)
Proper cleaning is the requirement for flawless operation of
the spray gun. Improper or lack of cleaning voids warranty
claims.
Always clean the spray gun and the container with the respec-
Adjustment
tive diluting agent (paint thinner or water) for the spray mate-
rial being used.
must be reduced.
Never immerse the complete spray gun into the cleaning
– Turn the thumbwheel
agent.
5 in direction I.
Never clean the nozzle and air holes of the spray gun with
pointed metal objects.
Do not pour diluted spray material back into the original spray
The spraying capacity
material drum/tin for storage.
must be increased.
Clean the spray gun thoroughly after having sprayed material
– Turn the thumbwheel
hazardous to one's health.
5 in direction IIII.
– Switch the base unit off and pull the trigger switch 9 of the
spray gun so that the spray material can flow back into the
container.
– Unscrew the container 8 and empty the remaining spray
material back into the original spray material.
English | 17
Maximum air
flow
Adjustment
The air flow must be re-
duced.
– Turn control knob 16 to-
ward the left.
The air flow must be in-
creased.
– Turn control knob 16 to-
ward the right.
1 609 92A 0BR | (14.10.13)