I Mportant S Afety I Nstructions For B Attery C Harger - Timbertech RSSR01 Original Bedienungsanleitung

11. WARNING:
The use of any replacement parts or accessories which are not recommended by the
manufacturer may present a risk of personal injury.
Ensure that the outside surface of the battery pack or the tool is clean and dry before
plugging in the charger.
Ensure that the battery pack is charged using the correct charger recommended by the
manufacturer, otherwise it may result in an electric shock, overheating or leakage of
corrosive liquid from the battery.
12. Have your tool repaired by a qualified person This tool was manufactured in accordance
with the relevant safety regulations. All repair work of the tool should only be carried out
by a qualified professional to prevent damage and/or personal injury.
13. 13. Disposal of the battery Ensure that the battery is disposed of safely according to the
instructions specified by the manufacturer.
i s
mpORtAnt AFety
1. Read the instruction manual carefully before using the battery charger.
2. CAUTION: This battery charger is only suitable to be connected to a 230V power outlet.
Never carry out the voltage detection with conductive objects as there is a risk of electric
shock or even electrocution.
3. Never attempt to charge the battery with any charger other than the one specified in this
manual.
4. Do not expose the charger to rain or snow.
5. This charger is not intended for any uses other than charging rechargeable batteries. Any
other uses may result in a fire, electric shock or electrocution.
6. Disconnect the charger from the power supply by pulling the plug rather than the cord.
7. Make sure that the cord is routed properly so that there is no danger that the cord may
inadvertently be pulled or cause anyone to trip.
8. This tool is ventilated through the slots on the top of the housing. Do not place any object
over the ventilation slots. Place the charger far away from any heat source.
9. Do not use the charger if it has been dropped, or damaged.
10. Do not disassemble the charger. Take it to an authorized service center when service or
repair is required.
EN
i
nstRuctiOns
48
F B
OR AtteRy
c
hARgeR