Inhaltsverzeichnis
Werbung
Trouble Shooting
Problem
The helicopter does not react
The motor does not turn
The helicopter is uncontrollable
The helicopter fails to climb
The helicopter lands too hard
The transmitter is not working
12
Possible Cause
No Power
The receiver is not receiving a signal
The batteries in the model or the
transmitter are empty.
The motor is too hot
The connection between the model
and the motor has been broken
The motor is wrong out
The transmitter antenna is not screwed
in securely or is not fully extended.
The wind is to strong
The rotor blades are not spinning fast
enough
The flieght battery is not fully charged
The throttle stick was pulled back to
fast
The transmitter is not switched on
The batteries are not incorrectly fitted
The batteries are empty.
Possible Cure
Check the connection between the flight
pack (battery) and the model
Make sure that the helicopter and the
transmitter are on the same channel
Charge the flight pack or change the
transmitter batteries.
Allow the motor to cool down.
Check the cables and re-solder if
necessary
Replace the motor.
Screw the antenna in and fully extend it.
Do not fly in wind.
Push the throttle stick further forward.
Fully charge the battery.
Pull the throttle stick back gently to
softly land the model
Switch the transmitter on
Fit the batteries correctly
Replace the batteries.
Werbung
Inhaltsverzeichnis
