Autostart; Servicing, Maintenance - HEYLO Base Classic Bedienungsanleitung

The Timer mode is left by pressing and holding down the Mode
button for more than two seconds or by operating the
Mode button in the timer menu until the Escape point is reached
and then confirming to leave the Timer mode by pressing the Enter key.

6.7 Autostart

If the mains plug is pulled when the timer is active or the operating voltage is interrupted, the fog
generator will start automatically in timer mode with the already set values when the device is put into
operation the next time.

7. Servicing, maintenance

Make sure that the ventilation slots are not blocked with dust deposits. The ventilation slots must
be cleaned, if necessary.
Avoid overheating of the device by adhering to the operating ambient temperature. For instance,
do not allow spotlights to shine directly onto the device.
Avoid to let the fog generator to run without fluid. Otherwise, the pump will run dry.
Immediately wipe off escaped fluid. Moisture - also fluid - will destroy the electronics.
From time to time, check the condition of the sintered filter. Clean or replace it, if necessary.
In case of frequent use of the same fluid can, you should thoroughly flush it prior to filling it with
flesh fluid. That way, you avoid impurities.
In case of a fixed installation of the fog generator, it must be made sure that fog-free air supply is
permanently guaranteed. Cooling air with too high a fog concentration can condensate in the
machine and cause moisture damage.
The can bracket can be screwed off for a fixed installation. (Caution: The height difference
between external can and machine may be 1.5 m at the maximum, because otherwise the pump
cannot suck the fluid any more!)
Clean the surface of the device with a suitable, solvent-free cleaning agent.
PLEASE NOTE: After every use with DRY ODOR products, flush the fog device with distilled
water.
16
EN