Initial Operation; Fog Fluids; Operation - HEYLO Base Classic Bedienungsanleitung

We are not aware of any case in which an unimpaired healthy person would have suffered harm in
any way due to the use of artificial fog. A prerequisite for this is the use of professional fog machines
with correct evaporating temperatures and fog fluids adjusted to them.
Our recommendation: Persons who have become ill or persons with pre-existing damages of the
respiratory tract or with an inclination to allergies should avoid contact with the generated fog!

3. Initial operation

Selection of the location: The location where the BASE CLASSIC is being operated, must:
be dry.
•
be free from dusty or dirty air.
•
be free from vibrations.
•
have a flame-proof footprint.
•
be well-ventilated with fresh, fog-free air.
•
The ambient temperature must be between 5° C and 45° C, the relative air humidity must be below
80%.
Replacing the can
Loosen the plug socket from the quick connector by pushing back the locking sleeve.
•
Remove the can from the bracket.
•
Screw the filler cap from the empty can and screw it on to a new or full can.
•
Put the full can back into the can compartment.
•
Put the plug socket firmly back into the quick connector until you hear a click and the plug socket
•
is firmly locked.

4. Fog fluids

The fog generator must be operated exclusively using the intended active substances:
Test fog
•
DRY ODOR products
•
The use of a third party fog fluid leads to the loss of guarantee cover.

5. Operation

ready for operation. Once the working temperature of the machine has been reached, the green
Ready LED starts flashing. If the final temperature has been reached, the LED will light up
continuously.
The Thermofogger is a fog machine with a strong emission. Any desired effect can be achieved, from
a small fog cloud up to a dense, room-filling fog. The fine adjustment of the pump enables fog
emission settings between 1 and 99 %.
Put the mains plug into a protective contact socket. Make sure there
is the correct working voltage (230V/50Hz). In the LCD display of the
control panel, a "P" and two figures will appear.
After a warming-up period of approx. 7 minutes, the device will be
12
EN