Stand-Alone Operation; Operation Via The Optional Radio Remote Control Or 0 - 10 V (+) Dc - HEYLO Base Classic Bedienungsanleitung

Setting the DMX start address
Press the Mode button
times until three figures will appear on the display.
Using the Up/Down buttons, now enter the desired DMX start address.
Save the start address by pressing the Enter button.
Now you can set the desired pump value via the panel. If you switch off the panel, the fog generator
will switch off automatically after 15 seconds.

6.3 Stand-alone operation

The fog generator can, of course, be operated in the so-called stand-alone operation.
Here the value of the pump is individually adjusted directly on the device.
To do so, press the Mode button
a "P" appears in the display together with two figures.
Using the Up/Down buttons, now set the desired pump value.
Press the Enter button briefly in order to start the fog process. The device will now be fogging
using the pre-set pump value (output) until the Enter button is pressed again.
The pump value can also be changed during the fog process by pressing the Up/Down buttons.
6.4 Operation via the optional radio remote control or 0 – 10 V (+) DC
Connect the fog generator to an analog panel or the optional cable remote control. To do so, use the
3-pole XLR socket on the back side of the device. When using the 0 – 10 V DC connection, please
observe the correct assignment of the plug.
DMX pin assignment and analog 0 –10 V DC
DMX: Pin 1 = Ground, Pin 2 = DMX-, Pin 3 = DMX+, Pin 4 and 5 = nc
3-pole XLR (analog): Pin 1 = Ground, Pin 2 = 0-10 V + DC in, Pin 3 = 12 V + DC out, max. 50mA
Plug in the connecting cable of the panel or the cable remote control into the relevant socket on the
back side of the device. You can regulate the pump value via the knob on the cable remote control or
the fader on the analog panel.
The fog process is started and stopped by operating the On/Off switch of the cable remote control.
on the control panel a number of
a number of times until
14
EN