HellermannTyton EVO7SP Betriebsanleitung Seite 39

EVO7 EVO7SP
Product description
1
Nosepiece
2
Blade
3
Nosepiece Screw
4
Trigger
5
Contoured Ergonomically Engineered Handle
Accessories
Spare Parts +
Bladekit (Blade + Screw)
110-70106
Tension adjustment
A1 Slide the thumb lever forward.
A2
While holding the thumb lever forward, rotate the tension knob to the desired tension setting.
A3 Release the thumb lever to lock the tension setting.
Tension cut off forces
Setting
Tension cut off force
The above figures are based on our knowledge and experience from practice and testing with a
commercially available force meter. Therefore these values are not legally binding but only for general
guidance. Because of the large number of possible influences during processing and use, it is advisable
to check the tension cut off forces with a usual tension gauge (frequency of data sampling should be
min. 10 kHz).
Recommended tension force
The following formula should be used for guidance as to the recommended tensile force of the tool:
Min. tensile strength
= rec. tensile force
2
0 1 2
20 38 51
6
Thumb Lever
7
Tension Lock Screw
8
Easy-to-read Tension Setting 0-8
9
Tension Knob
10
Setting recommendation
Calibration tool (CALTOOL)
110-70089
3 4 5
68 85 104
6 7 8
125 143 165