Herunterladen Inhalt Inhalt Diese Seite drucken

Setting The Gear Mesh; Electronic Speed Control (Esc); Electrical Layout - Electrix RC Boost Bedienungsanleitung

1/10 electric buggy
Inhaltsverzeichnis

Werbung

EN

SETTING ThE GEAR MESh

Gear mesh has already been set at the factory, and setting it is only
necessary when changing motors or gears.
note: You must remove the vehicle's gear cover (a) to do this
adjustment.

ELECTRONIC SPEEd CONTROL (ESC)

note: When motor disconnected or damaged, beep may not
be heard.
note: Low voltage cutoff (LVC) will stop the vehicle when the
battery gets low. The ESC will reset after approximately 10 seconds.
The vehicle can then be driven slowly back to the driver for
battery recharge.
beep beep
beep
beep beep

ELECTRICAL LAyOUT

Part #
Description
A
ECX1071
Motor
B
DYN1050
Battery 7.2V
C
ECX1069
Steering Servo
D
ECX1068
Receiver
E
ECX1070
Electronic Speed Control
(ESC)
note: For correct operation, Channels 1
and 2 must be used as shown in wiring
diagram. The motor can be disconnected
from the ESC at the connectors in
the wiring.
boost
8
A
LEd
beep
beep
beep
beep beep
beep beep
beep
beep beep
A
Motor
b
Battery 7.2V
C
AM Receiver Crystal (Rx)
Steering Servo
TM
Precautions
Never touch moving parts.
Never disassemble while batteries installed.
Always let parts cool before touching.
Proper gear mesh (how gear teeth meet) is important to the perf-
ormance of the vehicle. When gear mesh is too loose, the spur gear
could be damaged by the pinion gear of the motor. If the mesh is too
tight, speed could be limited and the motor and ESC will overheat.
1. Loosen the two (2) motor screws.
2. Put a small piece of paper between the pinion and spur gears.
3. Push the gears together while tightening the motor screws.
4. Remove the paper and the gears should move a small amount.
5. Reinstall gear cover.
LEd Status description LEd Indication
Solid Green
Solid Red
Red LEDs flashing with beep
Red LEDs flashing twice
with beeps
Red LEDs flashing three
times with beeps
beep
beep beep
AM Rx
Forward
Reverse
Transmitter is not
being received.
Signal that Vehicle
battery is low.
Motor is
overloaded or
temperature of
ESC is high.
E
Channel 2
Channel 1
d
Receiver

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ecx3000Ecx3000auEcx3100Ecx3100a

Inhaltsverzeichnis