Inhaltsverzeichnis
Werbung
INSTALLING VEhICLE bATTERy
1. Turn the thumb nuts to remove the battery strap.
2. Install the battery.
3. Install the battery strap.
4. Turn the thumb nuts to secure the battery strap.
5. Connect the battery.
OPERATING PRECAUTIONS
ANd GUIdELINES
•
ALWAYS turn on your transmitter before you turn on the
receiver in the car. Always turn off the receiver before
turning your transmitter off.
•
ALWAYS operate vehicle in a wide open area. Operating
the vehicle in a small space or indoors can cause overheating
at low speeds. Operating at low speed makes heat in the
electronic speed control (ESC). Overheating can damage
the vehicle and failure may result.
•
•
•
OPERATION
MOTOR CARE
Seat motor brushes by driving smoothly on a flat surface,
using the supplied Dynamite 1800mAh battery, during
use of the first battery charge.
Prevent overheat conditions to extend motor life.
Excessive motor wear results from:
Frequent turns
Stops and starts
Pushing objects
Driving in deep sand or tall grass
Driving continuously uphill
Over-temperature protection is installed on the ESC
to prevent circuit damage, but cannot protect the
motor from driving against heavy resistance.
•
ALWAYS keep parts dry.
•
ALWAYS keep moving parts clean.
•
ALWAYS use a clear radio frequency
•
ALWAYS keep vehicle in sight and under control.
•
NEVER touch moving parts.
•
NEVER operate vehicle with damaged wiring.
•
NEVER touch hot parts.
boost
5
TM
EN
Werbung
Inhaltsverzeichnis
