Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If water leaks from the overrun bore hole in the water supply, stop
working and have the tool repaired in an authorised service workshop.
While working, lead the line cord or extension cord to the back away
from the tool.
Electric tools have to be inspected by a specialist in regular intervals.
Never carry the tool at its cable.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
When working with this tool, wear ear protectors, dust mask and
goggles.
Make sure that persons in the work space are not endangered by
particles flying around.
Keep the handles dry, clean and free of oil and grease.
Always hold the tool with both hands.
Attention! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
Electrical Connection
First, check the correspondence between voltage and frequency against
the data mentioned on the identification plate. Voltage differences from
+ 6% to – 10% are allowed.
The machine is equipped with a soft start which prevents that swift
automatic circuit breakers are unintentionally triggered.
The EPN 1310 and EPN 1310 P are made in protection class II. For
protection purposes, the machine can only be run with a GFCI. For this
reason, the EPN 1310 is standard delivered with an encoded plug which
can be connected with an isolating transformer. And the EPN 1310 P is
delivered with a PRCD protective switch integrated in the cord to connect it
with a socket.
!
Attention!
The PRCD protective switch must not lay down in water.
PRCD protective switches must not be used to switch the
tool on and off.
Before starting your work, check the proper function by
pressing the TEST button
.
14
Werbung
