Herunterladen Inhalt Inhalt Diese Seite drucken

Before Initial Use; Operation - tepro Danville Bedienungsanleitung

Elektrogrill
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
4. Using some pressure, fit the grill
trough (14) onto the upper end of the
legs (10). Confirm that the legs and
the grill trough are connected
securely to each other.
5. Hook the wind/splash protection (2)
first into the two center recesses and
then into the left and right recesses.
6. Insert the hot plate (1) into the two
holes in the wind/splash protection
(2), and let the two rods on the side of
the hot plate (1) slide into the
provided notches on the left and the
right.
Note:
When the legs are not installed, the grill
can be used as a table-top grill.
Take care to use a level, fire-resistant
base.

Before Initial Use

1. Clean the grill grate and the drip pan
as described in the section
Maintenance and Cleaning.
2. Set the appliance onto a level, dry,
and non-slip surface.
3. Use a heat-resistant base when the
appliance is used as a table-top grill.
4. Let the appliance heat for approx. 10
min without food in order to burn off
production residues.
28
GB
5. Some smoke and corresponding
smell may occur with initial use. This
is normal and is caused by the
combustion of production residues.
The smoke and the smell disappear
after a short time. Please insure
sufficient ventilation of the room.
6. The appliance is ready for operation.

Operation

1. Remove the grill grate (3). Then
remove the temperature control (6)
up from the grill support (14), and
then pull it back with the heating
element (4) and remove it.
2. Approx. 1 liter of cold water can be
poured into the drip pan (8) to prevent
excessive smoke while grilling.
3. Refill water if the water level drops
while grilling. At this time, take care
that no water gets onto the heating
element.
4. Fit the heating element and the
temperature control back onto the grill
support by following the steps in
reverse. When doing so, it is
important that the temperature control
is fitted correctly into the recess (13)
of the grill holder (14). The safety
switch (brown) must be pushed in
completely. Otherwise the appliance
cannot be switched on.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis