Electrolux GA55GLV220 Benutzerinformation Seite 60

60 www.electrolux.com
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4), (5) and (6) flash.
3. Press button (3).
• The indicators of buttons (4), (5) and
(6) go off.
• The indicator of button (3) continues
to flash.
• The acoustic signals operate, e.g.
five intermittent acoustic signals =
level 5.
6.2 Filling the salt container
6.3 Filling the rinse aid dispenser
A B
A
+ -
C
D
• The display shows the current set-
ting of the water softener, e.g.
= level 5.
4. Press button (3) again and again to
change the setting.
5. Deactivate the appliance to confirm
the setting.
1.
Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt contain-
er (only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it,
after you fill the salt container,
start a programme.
1.
Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3.
Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between po-
sition 1 (lowest quantity) and posi-
tion 4 (highest quantity).