Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
• Please the product on a clean, horizontal and non-slippery surface. If required, place a
suitable pad under the product.
• Alternatively, the product can also be hung on a ceiling fixture with hooks under a ceiling.
Swing out the suspension bracket (2) at the bottom of the product and attach the product on
the hook. Make sure in this case that the hook has a sufficient capacity to hold the weight
of the product.
• Connect the round plug of the provided power adapter to the 15 V/AC 500 mA connection
socket (1).
• Connect the power plug of the power adapter to an appropriate outlet. Turn on the LED light
effect by flipping the on/off switch (3) to I position. The two LED light balls light up and begin
to rotate.
Make sure that the product can not fall down. By dropping equipment, serious
personal injury may be caused. Make sure that you are not staying in the rotation
range, to prevent injury and / or damage to the product.
• The rotation direction can be changed during operation. To do so, hold the device base (4)
with one hand and block one of the rotating LED balls (6) with the other hand. Once a
resistance is detected, the product rotates in the opposite direction. You can also change the
direction by briefly holding the product's rotational axis (5) above the base.
Do not block the product permanently.
• Set the on/off switch to O to turn off the device after use. Disconnect the power plug of the
power adapter from the wall socket when the device is not in use.
• Allow the product to cool down sufficiently before it is stored.
Cleaning and care
• Turn off and disconnect the product from the mains before each cleaning.
• Under no circumstances use aggressive cleanings agents, cleaning alcohol or other chemical
solutions since these can penetrate the housing or impair functionality.
• Never submerge the product in water or other liquids.
• Clean the product with a dry, fibre-free cloth.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product in accordance
with applicable regulatory guidelines.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
Technical data
a) LED light effect
Input voltage/current ..................... 15 V/AC 0.5 A
Power consumption ...................... 6 W ±0.5 W
LED power .................................... 2 x 1 W
LED ball Ø .................................... 2 x 128 mm
Operating conditions ..................... -20 to +55 ºC, 10 % – 85 % RH
Storage conditions ........................ -30 to +85 ºC, 10 % – 85 % RH
Dimensions (W x H x D) ............... 340 x 189 x 155 mm
Weight .......................................... 740 g
b) Power adapter
Operating voltage/current ............. 230 V/AC, 50 Hz
Output voltage/current .................. 15 V/AC 0.5 A
Cable length ................................. 2 x 1.5 m (input and output)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2016 by Conrad Electronic SE.
*1464695_v1_0816_02_hk_m_en
Werbung
Inhaltsverzeichnis
