Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Methods to Charge Battery:
1. Connect DVR to car charger through Mini-USB port,
DVR powers on automatically to enter standby mode and starts
charging with green indicator light ON.
Once DVR been fully charged, green indicator light goes out.
Connect DVR to computer via USB cable, DVR powers on
automatically to enter mode choice between 'Mass Storage
(MSDC)' and 'PC-Cam'; press 'UP' / 'DOWN' to choose the
desired mode and 'REC/OK' button to enter your choice and
start charging.
2. Once DVR been fully charged, green indicator light goes out.
[Note] During charging, it's permitted to turn off the DVR manually.
For the power capacity in the battery, refer to the following icons:
Full
Installation and Removal of Micro SD card:
1. In the direction as indicated, insert the Micro SD card into the
slot until it is held firmly.
2. To take the Micro SD card out, slightly press the Micro SD card
to eject it out.
− [Note] Observe the direction to insert the Micro SD card; if the
direction is reverse, the DVR and the Micro SD card may be
damaged.
− When the Micro SD card is inserted into the DVR, the machine
will set the Micro SD card as preset storage unit and the data in
the original Micro SD card will be unreadable.
− If the Micro SD card is incompatible with the DVR, please insert
the card again or replace it for retry.
Owner's manual
Middle
Low
EN
13
Werbung
