Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the hole in the mounting-bracket and over the trussing system or a safe fixation
spot. Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the EUROLITE LED KRF-144 4-Channel Light Bar to the mains, the device starts
running.
The LED display lights up and you can now choose the desired settings via the buttons MODE, ENTER, UP
and DOWN.
M
M
P
AIN
ENU
OINTS
- I
P
NTERNAL
ROGRAM AND
- S
C
OUND
ONTROL
- C
S
OLOR
ETTING
- E
L
„SC"
NDLESS
OOP
AND
- E
L
„FC"
NDLESS
OOP
AND
Internal Program and Speed Setting
Press the MODE and then the UP button until the display shows ASC-. Press the ENTER button
Via the UP or DOWN buttons, you can select the desired speed. Speed from A500 to A512, increasing.
DANGER TO LIFE!
International
L
N
S
S
PEED
ETTING
S
S
PEED
ETTING
S
S
PEED
ETTING
14/16
00077381.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
