General Setting - Scansonic PA6000 Bedienungsanleitung

PA6000
Any audio you play on your mobile device will now be streamed
to the unit.
Note: You will need to disconnect any connected mobile Bluetooth
devices from the unit to stream from a different Bluetooth device.
Bluetooth will automatically disconnect if you go out of range of
the unit. To manually disconnect you will usually need to use the
Bluetooth settings on your mobile device.
Note: Some legacy Bluetooth devices may prompt you to enter
a passcode when trying to pair with the unit. If this occurs, enter
the code 0000.

GENERAL SETTING

Info function
Under DAB+ mode, short press INFO to display below
information.
• Signal Strength
• Program type
• Ensemble/Multiplex
• Frequency
• Transfer Rate
• Time/date/Radio Text
Under FM mode, short press INFO to display below information
• Signal Strength
• Program type
• Frequency
• Auto/Stereo/Mono
• Time/date/Radio Text
Under AUX mode, short press INFO to display Time/Date
Under Bluetooth mode, short press INFO to display Time/Date
Menu function
Under DAB+ mode, short press Menu/Enter to into Menu, press
TUNE+/TUNE- to choose from Full san → Manual Tune → DRS
→ Prune → System.
Full scan: short press Menu/Enter to start full range search.
Manual tune: short press Menu/Enter to start full range search.
DRC: short press Menu/Enter to select DRC: DRC off/DRC low/
DRC high.
Prune: short press Menu/Enter to select Prune NO/YES.
Under FM mode, short press Menu/ Enter to into Menu, press
10