Error Codes; Accessories; Maintenance - IKA C-MAG HS4 Betriebsanleitung

Error codes

Footstep during the enterprise a disturbance up, is indicated these
with the devices to HS and HP by an error message in the display
(C). Whenever an error message appears switch the device off to
cool down.
Error Cause
code
E1 Inner temperature • switch off the unit and allow it
too high
E6 Motor seized
E9 Safety circuit
ETC
Have the device repaired if the error is not corrected using the
measures described or if another error code is displayed.

Accessories

Stirring organs
stirring bars: Ø 6 mm, lengts to 15mm
Ø 8 mm, lengts to 50mm
Ø10mm, lengt to 80mm
Any other accessories
RSE stirring bar remover
H36 holding rod
H16V support rod
H44 cross sleeve
6
ETS-D5 electrical contact thermometer
Solution
cool down
• Stirring bars inappropriate
• Reduce the viscosity
• Foreign bodies in the equipment
remove
• Plug the contact plug (G)
• Plug the contact thermometer
• Connecting cable, plug or
contact tthermometer defect,
exchange
Installing the support rod
The support rod is attached using the thraeded support bore (F).
• Screw nut M10 on to the support rod as far
as the stop
• Screw on the support rod as far as the
stop by hand
• Tighten the support rod and nut M10
using a flat wrench (SW17).
• Use bossheads to assemble
accessory parts or acces-
sory devices.

Maintenance

The appliance is maintenance-free.
Cleaning
Only use cleansing agents which have been recommended by IKA.
Use to remove:
Dyes isopropyl alcohol
Construction materials water containing tenside/ isopropyl alcohol
Cosmetics water containing tenside/ isopropyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
- Do not allow moisture to get into the appliance when cleaning
- Wear protective gloves during cleaning the devices.
- Before using another than the recommended method for clean-
F F
Fig. 3
CMAG 072010