Care And Cleaning; What To Do If - Electrolux ESI 66065 Benutzerinformation

28 electrolux
The pressure and temperature of the
water, the variations of power supply

CARE AND CLEANING

To remove and clean the filters
Dirty filters decrease the washing results.
Although the maintenance is very low with
these filters, make a check at intervals and
if necessary, clean them.
1. Turn the filter (A) counterclockwise and
remove it out from filter (B).
B
A
2. Filter (A) has two parts. To disassemble
the filter, pull them apart.

WHAT TO DO IF...

The appliance does not start or stops dur-
ing operation.
Malfunction
The appliance does
not fill with water.
Fault code
The display
shows
and the quantity of dishes can change
these values.
3. Fully clean the parts with water.
4. Put the two parts of the filter (A) togeth-
er and push. Make sure that they assem-
ble correctly in each other.
5. Remove the filter (B).
6. Fully clean the filter (B) with water.
7. Put the filter (B) to its initial position.
Make sure that it assembles correctly in
the two guides (C).
8. Put the filter (A) into position in filter (B).
Turn the filter (A) clockwise until it locks.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (acetone).
First try to find a solution to the problem (re-
fer to the chart). If not, contact the service
centre.
Possible cause
The water tap is
blocked or is furred
with limescale.
C
Possible solution
Clean the water tap.