Canon imageRUNNER ADVANCE 6265i Anwenderhandbuch Seite 53

2
Prepare the paper to load.
Open the packaging for the paper, and remove the paper
stack.
NOTE
•
For high-quality printouts, use paper recommended by
Canon.
•
Before loading paper, always fan the sheets several
times, and align the edges to facilitate feeding.
3
Load the paper stack into the paper drawer.
Paper Drawer (Right/Left)
Paper Drawer 3 and 4
1. Make sure that the paper size setting of the paper
drawer matches the size of the paper to load in the
paper drawer.
2. Load the paper stack against the right wall of the paper
drawer.
3. Gently push the paper drawer back into the machine
until it clicks into place in the closed position.
When returning the paper drawer to its original
position, be careful not to get your fi ngers caught, as
this may result in personal injury.
3
IMPORTANT
•
Paper which is curled must be straightened out before
loading it into the paper deck unit.
•
You will not be able to make copies or print if you load
paper that exceeds the loading limit mark (
the paper drawer is not completely pushed into the
machine.
•
Make sure that the height of the paper stack does not
exceed the loading limit mark (
•
Always check that the paper drawers are in place.
NOTE
•
When loading paper into the paper drawer for the fi rst
time, set the paper size plate to match the paper size
being loaded. (See "Adjusting a Paper Drawer to Hold a
Diff erent Paper Size, " on p. 52.)
•
The number of sheets that can be loaded in Paper
Drawer (Right/Left) is 1,500 sheets of paper (80 g/m
1,700 sheets of paper (64 g/m
•
The number of sheets that can be loaded in Paper
Drawer 3 and 4 is 550 sheets of paper (80 g/m
sheets of paper (64 g/m 2 ).
•
If there are instructions on the paper package
about which side of the paper to load, follow those
instructions.
•
When the paper is loaded into the paper drawer, the
side facing down is the one printed on.
•
If problems, such as poor print quality or paper jams
occur, try turning the paper stack over and reloading it.
•
For more information on the print direction of
preprinted paper (paper which has logos or patterns
already printed on it), see e-Manual > Copy.
•
Rewrap any remaining paper in its original package,
and store it in a dry place, away from direct sunlight.
•
If paper runs out and printing is stopped, load a new
paper stack. Printing restarts after the new paper stack
is loaded.
•
If you print on the paper which has absorbed moisture,
steam may come out from the output area of the
machine. This is because the moist on the paper
evaporates when the high temperature is applied when
a toner is fi xed to the paper. It is not a malfunction.
(This especially happens in low room temperature.)
Routine Maintenance
), or if
).
2 ) or
2 ).
2
) or 680
51