Conformity; Saving Energy; General Safety Information; Controls And Displays - Atag KD8178CD Gebrauchsanweisung

General safety information

1.3 Conformity

The refrigerant circuit has been tested for leaks. When
installed, this appliance complies with the relevant safety provi-
sions and EC directives 2006/95/EC and 2004/108/EC.

1.4 Saving energy

- Always ensure good ventilation. Do not cover ventilation
openings or grille.
- Do not place appliance in areas of direct sunlight or next to a
stove, heater or similar object.
- The energy consumption depends on the installation condi-
tions, e.g. the ambient temperature (see 1.2) .
Keep the time the appliance is open to a minimum.
-
- The lower the temperature setting, the higher the power
consumption.
- Store food logically. (see Appliance at a glance).
- Ensure that all food is well packed and covered for storage.
This will prevent frost from forming.
- First cool warm food to room temperature before storing it .
2 General safety information
Danger for the user:
- This appliance is not designed for persons (including chil-
dren) with physical, sensory or mental impairment or
persons not having sufficient experience and knowledge,
unless they are instructed in the use of the appliance and
are initially supervised by a person responsible for their
safety. Keep children under supervision to ensure they do
not play with the appliance.
In case of a fault, pull out the mains plug (not by pulling the
-
connecting cable) or switch off the fuse.
Have any repairs to or intervention in the appliance, and any
-
change of the mains power cable, carried out by the
customer service only or by other specialised personnel
trained for the purpose.
- When disconnecting the appliance from the supply, always
take hold of the plug. Do not pull the cable.
- Install and connect the appliance only as instructed.
- Please keep these instructions in a safe place and pass
them on to any subsequent owners.
Fire hazard:
The refrigerant R 600a is environmentally friendly but flam-
-
mable. Escaping refrigerant may ignite.
• Do not damage the refrigerant circuit pipes.
Do not allow naked flames or ignition sources to enter the
•
appliance.
Do not use any electrical appliances in the interior (e.g.
•
steam cleaners, heaters, ice cream maker etc.).
If refrigerant escapes: eliminate naked flames or sources
•
of ignition from the vicinity. Pull out the power plug. Venti-
late the area well. Notify customer service.
- Do not store explosives or sprays using combustible propel-
lants such as butane, propane, pentane, etc. in the appli-
ance. Respective spray cans can be identified by reference
to the contents printed on the can or by a flame symbol.
Gases possibly escaping may ignite due to electrical
components.
Only store high-percentage alcohol in tightly sealed, upright
-
containers. Alcohol possibly escaping may ignite due to
electrical components.
Danger of tipping and falling:
- Do not misuse the plinth, drawers, doors etc. as a step or for
support. This applies particularly to children.
- Use the appliance only in the built-in state.
Danger of food poisoning:
Do not consume food which has been stored too long.
-
18
Danger of frostbite, numbness and pain:
- Avoid lasting skin contact with cold surfaces or refrigerated/
frozen food or take protective steps, e.g. wear gloves. Do
not consume ice cream, water ice or ice cubes immediately
and do not consume them too cold.
Please observe the specific information in the other
sections:
DANGER identifies a situation involving direct
danger which, if not obviated, may
result in death or severe bodily
injury.
WARNING identifies a dangerous situation
which, if not obviated, may result in
death or severe bodily injury.
CAUTION identifies a dangerous situation
which, if not obviated, may result in
minor or medium bodily injury.
NOTICE identifies a dangerous situation
which, if not obviated, may result in
damage to property.
Note identifies useful information and tips.

3 Controls and displays

3.1 Operating and control elements

Fig. 2

(1) Temperature display

(2) "-" setting button
(3) "+" setting button
(4) On/Off button
3.2 Temperature display
The following are displayed in normal operation:
- the warmest freezing temperature
The temperature display flashes:
the temperature setting is being changed
-
- after switch-on the temperature is not yet cold enough
the temperature has risen several degrees
-
Dashes flash in the display:
- the freezer temperature is above 0 °C.
The following displays indicate malfunction. Possible causes
and corrective action (see Malfunction).
nA
-
- F0 to F5
(5) FastFreeze button
(6) Alarm button
(7) Child lock symbol