Tips For Energy Saving - Atag KS1088CUU Gebrauchsanweisung

gebrauchsanweisung

tips for energy saving

important
54
· Try not to open the door too often, especially when
the weather is wet and hot. Once you open the
door, mind to close it as soon as possible. This is
especially important if you have an upright model.
· Every now and then check if the appliance is
sufficiently ventilated (adequate air circulation behind
the appliance).
· Turn the thermostat knob from higher to lower
setting as soon as possible (depends on how loaded
the appliance is, ambient temperature...)
· Never use continuous operation unless unnecessarily
required; switch the operation mode selection switch
to the setting for automatic operation as soon as
possible.
· Before freezing packages of fresh foods, make sure
they are cooled to ambient temperature. (except for
the soup)
· Ice and frost layer increase energy consumption, so
do clean the appliance as soon as the layer is 3-5
mm thick.
· If the gasket is damaged or if it turns out that
the sealing is poor, the energy consumption is
substantially higher. To restore efficiency, replace
the gasket.
· The condenser on the rear wall should be always
clean, free of dust or any impurities.
· Always consider instructions stated in sections
Positioning and Energy Saving Tips, otherwise the
energy consumption is substantially higher.
· If you've bought this appliance to replace an old one
equipped with a lock that cannot be opened from
inside (lock, bolt), make sure that the lock is broken.
This will make it impossible for the children to lock
themselves in the appliance and suffocate.
· Mind to connect the appliance correctly to the mains
supply (see Connection to the Mains Supply).
· Do not touch the cooled surfaces while the appliance
instructions for use
before putting into use