Siemens TK52F09 Gebrauchsanleitung Seite 19

en
● Wipe out or vacuum the inside of the
appliance (tray holders).
● Open the doors to the brewing unit 1
and remove any coffee residues. Close
the doors.
Note: If the appliance is cold when
switched on with the stand­by button
it is set to stand­by after brewing coffee, it is
automatically rinsed, i.e. the system cleans
itself.
Nozzle 8 for hot water/steam
● Unscrew the nozzle 8 from the steam
pipe.
● Dismantle all parts (Fig. D).
● Clean with a caustic cleaning solution and
a soft brush. Clean the tip of the nozzle
8/c with a blunt needle.
● Thoroughly rinse and dry all parts.
Service programme:
Combined cleaning and
descaling process
S
If the LED lights up while the appliance
is on, the service programme must be
run immediately to clean and descale the
appliance. If the service programme is not
run as instructed, the appliance may be
damaged.
Specially developed descaling (Order
No. 310451) and cleaning agents (Order
No. 310575) can be obtained from our
customer service department.
Warning
Each time you run the service programme,
follow the instructions for using the cleaning
and descaling agents.
Never interrupt the service programme.
Do not drink the liquids.
Never use vinegar or vinegar-based
products.
Never put descaling tablets or other
descaling materials into the duct for
cleaning tablets.
LED flashes while the service
i S
The
programme is running (approx. 40
minutes).
Important: If there is a filter in the water
tank, it must be removed before the service
programme is run.
a
, or if
Starting the service programme
● Switch the appliance to stand­by mode
using the stand­by button
● Empty and replace the trays 17 and 18.
● Hold down the mild coffee button
least 5 seconds.
LED starts to flash and the
† The S
appliance rinses the coffee dispenser
through twice.
● Empty and reinsert the grounds tray 17.
† The steam button LED
H
LED lights up.
● Place one cleaning tablet in the duct 13.
● Fill the water tank with lukewarm water,
add descaling agent and dissolve
completely (total liquid: 0.5 litres).
or
● Pour prepared descaling mixture into the
water tank (total liquid: 0.5 litres).
● Press the steam button
process begins. Duration approx. 10
minutes. The descaling solution flows into
the water tray 18.
† The J
● Place a suitable container (approx. 0.5
litres) under the nozzle 8.
● Set the dial 6 to
process begins. Duration approx. 5
minutes. The descaling solution flows into
the container.
I
† The
● Empty and reinsert the grounds tray 17.
† The steam LED
● Empty and clean the water tank 11, fill
with fresh water up to the "max" mark and
reinsert.
h
h
LED flashes.
g h
/ . The descaling
LED lights up.
flashes.
h
en
15
a
.
5
for at
flashes and the
. The descaling
15