Siemens TK52F09 Gebrauchsanleitung Seite 15

en
Switching on the appliance
● Pull enough of the power cord out of the
storage compartment and plug it into the
electrical socket.
● Remove and rinse the water tank 11
and fill it with fresh cold water. Do not fill
above the "max" mark.
● Replace the water tank 11 and push it
firmly down into place.
● Fill the bean container with coffee beans.
● Set the power switch 1 to I. The stand­by
a
LED lights red.
● Make sure that the hot water/steam dial 6
is at O.
● Press the stand­by button
LED flashes.
Filling the system
When switched on for the first time, the
water pipes in the appliance must be filled.
● Place a cup under the nozzle 8.
● Turn the dial 6 to
the cup.
J
As soon as lights up, turn the dial 6
back to O.
● The stand­by button
appliance rinses and heats up.
The appliance is ready for use when the
a
stand­by LED lights green.
i
The appliance's factory settings are
programmed for optimal performance.
Controls
1 Power switch
The power switch 1 on the rear of the
appliance switches the power supply on
and off.
When the power is switched on, the
a
standby LED lights red.
The appliance is now in stand­by mode.
Warning
Do not press the power switch while the
appliance is operating. The appliance
should only be switched off when it is in
stand-by mode.
a J
. The
g h
/ . Water runs into
will now flash. The
a
 Stand­by button
The stand­by button
appliance from stand­by mode to on.
When the stand­by button
appliance heats up. The stand­by button
flashes while the appliance heats up and is
rinsed. When the stand­by button
green, the appliance is ready for operation.
The appliance will not be rinsed if:
– it is still warm when switched on, or
– coffee was not dispensed before it was
switched to stand­by mode.
Note: After 3 hours, the appliance
automatically switches to stand­by mode.
3 Coffee dispensing button
(mild coffee)
This button is used to dispense mild coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
4 Coffee dispensing button
(strong coffee)
This button is used to dispense strong
coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
5 Steam generation button
The steam button
foaming or warming.
6 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to
steam, the steam generation button
must be pressed first (see "Steam for
frothing milk").
7 LED display
The various LEDs indicate the following:
H
on The water tank is empty and
needs to be filled.
I
on Trays full:
Empty and replace them.
flashing T rays missing:
I
Reinsert them.
a
a
switches the
a
is pressed, the
a
5
K
h
h
generates steam for
g h
or . To dispense
en
11
a
lights
h
11