Kalorik KA EXP 4 C Gebrauchsanleitung Seite 19

Fax +32 2 359 95 50

ATTENTION: PAY ATTENTION NOT TO GET BURNED WITH THE STEAM AND THE
METAL PART OF THE PIPE (WHICH MAY BE HOT). BE EXTREMELY CAREFUL IN
ORDER NOT TO GET BURNED.
Coming back from the cappuccino to the expresso
Once again press the Steam/Hot water (d) to switch if off, it lets the appliance cool down. Place a
container under the pipe turn the steam control knob (b) and simultaneously press the READY switch
(e) so that water can go out through the steam pipe (h) until having filled a cup with water.
Press again on the switch (e) and close the steam control knob (b). The appliance is now ready to
make espressos. Therefore, read the instructions HOW TO PREPARE AN EXPRESSO.
HOW TO PREPARE A TEA OR ANOTHER HOT BEVERAGE
After having followed the instructions concerning the first use, place a container under the
steam/water pipe (h) and press the Expresso switch (c) when the pilot light (o) comes on. Press on the
switch (e) and at the same time open the steam control knob (b) in order to obtain hot water through
the steam pipe (h).
CLEANING
The body of the appliance: before cleaning the appliance, switch it off, remove the plug from the
wall socket and wait until it cools down. Wipe the body of the appliance with a damp cloth. Never
immerse the body of the appliance in water or any other liquid.
Filter: If the holes are blocked by coffee residues, you can wipe them with a brush (fig. 11).
Support of the filter holder: The ground coffee residues can be removed with a toothpick.
Steam pipe for cappuccino: See paragraph "How to prepare a cappuccino".
BarCREAM®DISK: Separate both parts and wipe them under hot water before assembling them.
Drip tray: In order to clean the drip tray remove it.
Attention: Never try to open or to disassemble the body of the appliance.
DESCALING
The expresso machine has to be descaled regularly. The frequency depends on the water hardness and
of the use frequency.
1. Remove the scale and the coffee residues from the filter grid and from the support of the filter
holder. It is recommended to use only liquid descaling agent that can be found in shops and in
the proportions indicated on the packing paper by the producer.
2. Place one container under the support of the filter holder and another one under the steam pipe
(h) (Attention: do not use the filter holder (f) during the descaling).
3. Press the ON Switch (c) and turn the steam control knob (b) in the open position and then press
the switch (e). Wait until steam comes out the opening of the pipe (h).
4. After approximatively 30 seconds, stop the hot water flow by closing the steam control knob (b)
and let the descaling solution flow through the support of the filter holder in the container.
5. When the solution has finished flowing, switch off the appliance and let it cool down.
6. Repeat this operation a second time.
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don‟t change the page
numbering. Keep the languages integrity.
Assembly page 19/36
19