Kalorik KA EXP 4 C Gebrauchsanleitung Seite 17

Fax +32 2 359 95 50

ATTENTION in the explanations the letter "A" is different from "a".
The capital letters correspond to the coffee maker and the small letters to the expresso.
SPECIAL SAFEGUARDS CONCERNING THE CARAFE
In order not to break the carafe:
Do not wait that all the liquid has evaporated from the carafe. Don‟t heat the carafe when it is empty.
Change your carafe if it is damaged.
If it is chipped or cracked, it could break or let glass particles enter the liquid.
Do not place the hot carafe on a cold or wet surface.
Do not use the carafe if the handles are cracked or broken.
Do not use metal sponges to clean the carafe, they could scratch and weaken the glass.
Do not place the carafe on or near an electric or gas stove, in a oven or in a microwave oven.
Avoid shocks.
PREPARING THE MACHINE
Check if all switches are on the OFF position and the lights are OFF.
Check that the steam control knob (b) is closed by turning it clockwise.
We recommend to get used to all functions of your appliance before using it for the first time.
Wash the accessories thoroughly in hot soapy water, rinse and dry them carefully.
Fill the tank (A) with cold water.
EXPRESSO FUNCTION
How to prepare an authentic espresso?
The espresso is a strong coffee, with a characteristic taste, extremely rich in aroma. Therefore, the
water which arrives in the filter with a high temperature is pushed very fast through the coffee mass
by a strong pressure. It extracts the nectar from the grinding and draws the essential aromas from the
coffee. That‟s why the espresso is usually served in small "espresso" cups.
Use preferably a special espresso coffee with suitable roasting and grinding.
Remember that the espresso needs a finer grinding than the filter coffee.
BEFORE THE FIRST USE
When you use your appliance for the first time we recommend in order to wash the inner side of the
appliance circuit, you have to operate it three times as described in the section HOW TO PREPARE
AN EXPRESSO (WITHOUT COFFEE IN THE FILTER HOLDER).
HOW TO PREPARE AN EXPRESSO
1. Fill the tank (A) with cold water (Fig. 1).
2. Switch on the appliance by pressing the ON/OFF switch (c), the pilot light (m) will come on.
3. Place the BarCREAM®Disc (l) in the filter holder (f) (Fig.2) and insert the filter (j). Fill it with
ground coffee (Fig.3), pour a coffee measure for one cup and two measures for two cups. To
measure out, use the measuring spoon (k). Genlty tamp the coffee with this spoon (k) remove the
excess coffee from the edge of filter holder (f). This will ensure the good positioning of the filter
holder in its support.
4. Position the filter holder (f) in the support of the filter holder (g). Turn firmly to the right until it
blocks (Fig. 4). The filter holder (f) should be the most possible on the right of the closing zone
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don‟t change the page
numbering. Keep the languages integrity.
Assembly page 17/36
17