Operating Your Wine Refrigerator; Problem Disposal; Possible Cause - Caso SC-12B Betriebshandbuch

Operating Your Wine Refrigerator

It is recommended that you installed the wine refrigerator in a place where the ambient temperature is
between 18-26°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected. For example, placing in extreme cold or hot conditions may cause
interior temperature to fluctuate. The range of 10-16°C may not be reached.
The temperature may fluctuate depending on whether or not the interior light is on or off or whether the bottles
are located on the upper, middle or lower section.
Any of the wine shelves can be removed to accommodate larger bottles.
How to use the press-buttons on the Display Panel
You can set the temperature as your desire by pressing the button. There are three press-button on the panel
" " and " " to adjust the temperature by 1°C among 7-18°C. You can tune the interior light on or off by
pressing the "Light" button.

Problem disposal

You can solve many common wine refrigerator problems easily, saving you the cost of a possible service call.
Try the suggestion below to see if you can solve the problem before calling the service center.
PROBLEM
Wine refrigerator do not operate.
Wine refrigerator is not cold enough.
The light does not work.
Vibrations.
The wine refrigerator seems to make to
much noise
The door will not close properly.
LED could not display.
LED display error - Lo
Bottoms are not functional.

POSSIBLE CAUSE

Not plugged in using different voltage. The circuit
breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct
clearance.
Check the service center.
Check to assure that the wine refrigerator is level.
The wine refrigerator is not level.
Check the fan.
The wine refrigerator is not level.
The doors were reversed and not properly installed.
The seal is weak.
The shaves out of position.
Main control board does not work.
PCB Problem.
There is some problem with the plug.
Weak quality of display.
Temperature point is out off. Check the service center.
Temperature controller panel is damaged.
13