Precautions You Must Take; Extraction Systems; Controls - Pelgrim RSK986 Anleitung

safety
20

Precautions you must take

■ Have the appliance connected by a qualified fitter (see section "Installation").
■ The metal panels can be removed by pulling them directly downwards. Use
both hands for this purpose.
■ The metal panels get hot during cooking. Wait 30 minutes before start
cleaning the panels after cooking.
■ The power supply must be disconnected before the appliance is cleaned or
repaired. Remove the plug from the socket or switch the electricity off at the
mains.
■ We advise you to switch the cooker hood on before you start cooking. Leave
the cooker hood on for another 5 minutes or so after you have finished
cooking.
Fats and oils become inflammable on overheating. Never leave such foods
■
unattended during preparation.
A grease-saturated filter mat is inflammable, so never flambé under the
■
cooker hood, and clean the filter regularly.
Switch off the electricity before replacing the light bulbs! Only use the same
■
sort of light bulbs with the same Wattage.
In view of possible sharp edges on the chimney we advise you to wear
■
working gloves when fitting the chimney.

Extraction systems

The extractor hood must be connected to a duct.
The cooking vapours extracted by suction are carried outside, once the vapours
have been filtered. The cooker hood is connected to the duct at the top using
the outlet flange supplied.
use
21
Controls (RSK595/RSK986)
1
Switching lighting on and off
Press the lighting button
The lighting comes on.
Press the button again and the lighting goes out.
Switching on the fan
1 2
Press the , or
The extractor hood comes on at the setting selected. The control light between
the buttons lights up.
Controls (RSK975/RSK981)
Switching lighting on and off
Press the lighting button
The lighting comes on.
Press the button again and the lighting goes out.
Switching on the fan
Press the button.
The extractor hood switches on.
Change the speed by pressing speed switch
2 3
.
3
button.
.
or .