5. Switch the device off after use with the on/off switch and open the battery
compartment. There is a brush located in the lid.
6. Brush the shear blade with the cleaning brush with a series of star-shaped
movements.
7. After cleaning insert the cleaning brush back into the holder and close the
battery cover.
ATTENTION:
Depending on the quantity of cut hair it is advisable to thoroughly clean the
device from time to time as described below in „Cleaning"!
•
Before cleaning switch the device off with the on/off switch. Open the battery
compartment. Remove the cleaning brush from the fi cxture.
•
Turn the shearing head counter-clockwise to remove it and pull it out. Remove
the shear blade with caution. Warning: the shear blade is sharp! DANGER OF
INJURY!
•
Brush the shearing head and the clamp in a star-shaped manner. Remove
even the smallest bits of hair by blowing.
•
Do not dip the device or any parts of it in water!
•
Insert the shearing blade starting from the cutting surface back on the shea-
ring head.
•
Place the shearing head on the device's drive shaft and turn it clockwise to
tighten it.
•
After cleaning, fi t the cleaning brush back into the support. Insert the battery
again and close the battery compartment.
•
Push the protection cap back on the shearing head.
Model: ................................................................................................HSM 2697 NE
Battery charging time (Hair-clipper): .................................................approx. 8 hours
Power supply (Mains adapter): ............................................................. 230 V, 50 Hz
Protection class (Mains adapter): ........................................................................... ΙΙ
Power consumption (Hair-clipper):.............................................. DC 2,8 V, 1200 mA
Battery (Nose hair trimmer): ....................... 1x 1,5 V, Typ: MIGNON LR6, AA, UM3
05-HSM 2697 NE Neu 57
Cleaning
Technical Data
GB
57
18.11.2005, 14:26:53 Uhr