Clatronic hsm 2697 ne Bedienungsanleitung Seite 54

Special Safety Advice for this Machine
• Only dry hair should be cut with this machine.
• Only use the machine for cutting hair.
• Do not use the device near water (e.g. bathtubs, sinks or other containers fi lled
with water).
Use with the Mains Adapter (Battery Machines)
• Connect the machine to the mains adapter.
• Connect the device to a duly installed 230 V/50 Hz protective contact socket.
The device can now also be used when the batteries are fl at.
Charging the Battery
Before the machine can be used without a cord, the battery must be charged.
• Turn the device off.
• To charge up the device, insert the plug of the power pack into a 230 V/50 Hz
socket and then connect the cable with the connection socket of the charging
station or directly with the device.
• The charge control lamp now illuminates.
GB
• The fi rst time charging will take approx. 10 hours; for subsequent charging will
take´approx. 8 hours. Then disconnect the mains adapter.
NOTE:
• The lamp (6) does not give any indication of the charge level of the battery.
The charging lamp on the drive unit lights up when there is contact with the
mains adapter.
• Do not leave the device connected to the charger more than necessary,
otherwise the life of the batteries risks being shortened.
• Let the batteries run out completely before charging again.
Preparing for Cutting
1. Briefl y comb the hair.
2. Oil the blades slightly.
3. Push the blade protector (3) to the rear so that the shearing blade is uncovered.
4. Place a cutting length guide suitable to the desired cutting length. If you are
not sure of the cutting length, start from 16 mm. The setting can be read off in
the display (2).
54
05-HSM 2697 NE Neu 54
Hair-clipper
Use of the Hair Cutter
18.11.2005, 14:26:46 Uhr