Start Up; Dry Vacuum Cleaning; Wet Vacuum Cleaning - Flex VCE 45 L AC Bedienungsanleitung

Start up

The appliance allows 2 operating modes:
1 Industry vacuum cleaner mode (socket
not used)
2 Dedusting mode (socket used)
 Connect the suction hose and insert the
suction nozzle or connect to the dust-
generating device depending on the op-
erating mode.
WARNING
The flat pleated filter must always be in
place while vacuuming.
WARNING
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
Anti-static system
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks with attachments with electro-
statically grounded accessories included in
the delivery.

Dry vacuum cleaning

– The device is equipped with a paper fil-
ter bag with a locking slide, VCE 35 - or-
der no. 296.961 (5 pc) or VCE 45 - order
no. 340.758 (5 pc).
– The appliance is equipped with a dis-
posal bag with locking slide and locking
strip, order no. 340.766 (10 pc).
Note: You can use this appliance to vacu-
um all types of dust up to dust class L. It is
statutorily necessary to use a dust collec-
tion bag (see Filter systems for order num-
ber).
Note: The appliance is suited as industrial
vacuum cleaner to take up dry, non-com-
bustible dusts with AGW values greater
than or equal to 1 mg/m
– When vacuuming up fine dust, a paper
filter bag or a disposal bag must addi-
tionally be used.
.
3
EN
Installing the paper filter bag
Illustration
 Release and remove the suction head.
 Fit the paper filter bag.
 Insert and lock the suction head.
Install disposal bag
Illustration
 Release and remove the suction head.
 Mount the disposal bag.
 Place the disposal bag over the con-
tainer.
 Insert and lock the suction head.
Changeover from wet to dry vacuum
cleaning
ATTENTION
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter ele-
ment is still wet the filter will become ob-
structed and may be damaged beyond re-
pair.
 Dry the wet filter properly before use or
replace it with a dry one.
 Change the filter, if required, according
to instructions under the section "Main-
tenance and Care".
Note: For permanent wet vacuum cleaning
it is advisable to use a PES flat pleated filter
(see filter systems).

Wet vacuum cleaning

WARNING
No dusts hazardous to health should be
sucked in during wet vacuuming.
Removing the paper filter bag
Illustration
 Release and remove the suction head.
 Pull the paper filter bag out towards the
back.
 Pull up the locking slide and tightly
close the paper filter bag upon removal.
 Dispose of the used paper filter bag ac-
cording to the statutory provisions.
 Insert and lock the suction head.
– When vacuuming up wet dirt, the paper
filter bag must always be removed.
– 3
17