Electrical Wiring Connection - Daikin FWC02AAFNMV1 Installationshandbuch

Kaltwasser-ventilatorluftkühler

Inhaltsverzeichnis

Verfügbare Sprachen

This is a proposed wiring connection. It may change subject to the chiller unit and must comply with local and national code and

regulations.

FCU 1

HVLV CVLV

L/L1 N/L2 N/L2

3WV 3WV

CHILLER

Model : FWC02AAFNMV1 / FWC03AAFNMV1 / FWC04AAFNMV1 / FWC05AAFNMV1 / FWC06AAFNMV1 (W2.0-4P)

HEAT COIL SENSOR

COLD COIL SENSOR

RETURN AIR SENSOR

WIRED

CONTROLLER

LED/IR RECEIVER

LEVEL SWITCH

RED

BLACK

AIR SWING

MOTOR

FIELD SUPPLY WIRING

WITH JUMPER FOR HEAT PUMP

WITHOUT JUMPER FOR COOLING

WITH JUMPER FOR VALVE APPLICATION

WITHOUT JUMPER FOR VALVELESS APPLICATION

Note: Unit comes in standard heatpump and for valve application.

IMPORTANT:

* These values are for information only. They should be checked and selected to comply with local and/or national

codes and regulations. They are also subject to the type of installation and size of conductors.

** The appropriate voltage range should be checked with label data on the unit.

A main switch or other means for disconnection, having a contact separation in all poles, must be incorporated

in the fixed wiring in accordance with relevant local and national legislation.

Model

Voltage range**

Recommended fuse* (A)

Power supply cable size* (mm

Number of conductors

• All wires must be firmly connected.

• All wires must not touch the water piping, or any moving parts of the fan motor.

• The power supply cord must be equivalent to H05VV-F (60227 IEC 52 or 60227 IEC 53) which is the minimum requirement,

and to be used in protective tube.