Supplied Accessories - Yamaha NS-F700 Bedienungsanleitung

SUPPLIED ACCESSORIES

After unpacking, check that the following parts are contained.
(L) (R)
Stand (R × 2, L × 2)
Wood screw
(4mm (3/16")) × 4
ATTACHING THE STANDS
When placing the speakers, be sure to use the stands to increase
stability.
Notes
• Make sure to have another person support it.
• Pay extra attention to avoid scratching on the speaker's
surface.
• Place the speaker on a supporting surface (height of 7 cm
(2-3/4") or more). Use a blanket or a cushion on it to avoid
scratching.
• The provided stands are in two types. Two stands are for the
right side and others are for the left side. Attach each stand
to the proper position on the bottom of the speaker by
following the figure below.
• To attach the stands to the speaker, be sure to lay down the
speaker with the side facing up.
(R)
Back
(L)
View from the bottom of the speaker
Use the 8 specified holes located on the base of the speaker.
■Procedure
1
2
3
Screw
4
(6mm (1/4")) × 4
5
Pad × 4
Note
(L)
Be carefully not to apply force to the side of the speaker,
otherwise the speaker may fall causing damage to the speaker
or personal injury.
Front
(R)
Put the 6 mm (1/4") screw through the large hole in the stand,
and screw it into the speaker at one of the outside holes in the
base of the speaker.
At this time, screw it in loosely so that the stand can still be
moved.
Put the 4 mm (3/16") wood screw through the other hole in the
stand, and screw it into the other hole in the base of the
speaker.
Tighten both of the screws firmly.
Attach a pad to the bottom of the end portion of the stand.
Attach the other stands to the other corners of the base of the
speaker in the same way and confirm that all 4 stands have
been firmly attached.
Pad
Screw (6mm (1/4"))
Wood screw (4mm (3/16"))
1
En