Install User Profile - AXENT .ELI Bedienungsanleitung

BASIC SETTING
LED NIGHT LIGHT
The LED night light provides orientation during the night. To activate or deactivate
Temp the Led night light, press « S hift » and at the same time « T emp » .
Shift
Finish the setting by releasing the « S hift » button.
Front Rear
Two LED lights indicate the selected level.
Stop
Press « S hift » and at the same time «Temperature » again to turn off the night light.
Dry Massage
One LED light indicates the selected level.
With an additional press on « S hift » and at the same time « T emperature » the night
light will switch into the automatic mode. Three LED lights indicates the selected
Flow Temp Position
level. Night light will turn-off and -on automatically depending on light incidence.
2
This mode is available on models E81.1011.0000.1, E81.1011.0000.2 and
User1 Eco User2
E82.1011.0000.1, E82.1011.0000.2 only.
Shift
To set and see the LED night light, open the lid during daylight and setting.
10

INSTALL USER PROFILE

SAVE
The shower toilet permits to save 2 individual user profiles. The chosen settings are identical
for rear or Lady-shower.
Please sit on the shower toilet to start the settings.
To program the settings consult the points below.
– Water intensity indicator
Front Rear – Nozzle position indicator
– Shower temperature
Stop
– Air dryer temperature
Dry Massage
– Seat heating
All made adjustments can be saved now.
Flow Temp Position
1 2
User 1 User 2 Press « S hift » and at the same time «User 1» or «User 2 ».
2
An accoustic signal will confirm your saved settings.
User1 Eco User2
Shift
Shift
Following settings can be saved as well without you having to sit on the shower toilet:
– Shower temperature
– Air dryer temperature
– Seat heating
Modification or change of user profile can be done anytime.
Page 16
Page 16
Page 18
Page 19
Page 19
Page 18
Page 19
Page 19
11